Edit: /usr/share/openmpi/help-orte-runtime.txt (3442B)
# -*- text -*-
#
# Copyright (c) 2004-2005 The Trustees of Indiana University and Indiana
# University Research and Technology
# Corporation. All rights reserved.
# Copyright (c) 2004-2005 The University of Tennessee and The University
# of Tennessee Research Foundation. All rights
# reserved.
# Copyright (c) 2004-2005 High Performance Computing Center Stuttgart,
# University of Stuttgart. All rights reserved.
# Copyright (c) 2004-2005 The Regents of the University of California.
# All rights reserved.
# Copyright (c) 2021 Nanook Consulting. All rights reserved.
# $COPYRIGHT$
#
# Additional copyrights may follow
#
# $HEADER$
#
# This is the US/English general help file for Open MPI.
#
[orte_init:startup:internal-failure]
It looks like orte_init failed for some reason; your parallel process is
likely to abort. There are many reasons that a parallel process can
fail during orte_init; some of which are due to configuration or
environment problems. This failure appears to be an internal failure;
here's some additional information (which may only be relevant to an
Open MPI developer):
%s failed
--> Returned value %s (%d) instead of ORTE_SUCCESS
#
#
[orte:session:dir:prohibited]
The specified location for the temporary directories required by Open MPI
is on the list of prohibited locations:
Location given: %s
Prohibited locations: %s
If you believe this is in error, please contact your system administrator
to have the list of prohibited locations changed. Otherwise, please identify
a different location to be used (use -h to see the cmd line option), or
simply let the system pick a default location.
#
[orte:session:dir:nopwname]
Open MPI was unable to obtain the username in order to create a path
for its required temporary directories. This type of error is usually
caused by a transient failure of network-based authentication services
(e.g., LDAP or NIS failure due to network congestion), but can also be
an indication of system misconfiguration.
Please consult your system administrator about these issues and try
again.
#
[orte_nidmap:too_many_nodes]
An error occurred while trying to pack the information about the job. More nodes
have been found than the %d expected. Please check your configuration files such
as the mapping.
#
[orte_init:startup:num_daemons]
Open MPI was unable to determine the number of nodes in your allocation. We
are therefore assuming a very large number to ensure you receive proper error
messages.
#
[failed-to-uncompress]
A compressed message was received by the Open MPI run time system
(PMIx) that could not be decompressed. This means that Open MPI has
compression support enabled on one node and not enabled on another.
This is an unsupported configuration.
Compression support is enabled when both of the following conditions
are met:
1. The Open MPI run time system (PMIx) is built with compression
support.
2. The necessary compression libraries (e.g., libz) can be found at
run time.
You should check that both of these conditions are true on both the
node where mpirun is invoked and all the nodes where MPI processes
will be launched. The node listed below does not have both conditions
met:
node without compression support: %s
NOTE: There may also be other nodes without compression support.