/usr/src/linux-headers-5.15.0-181/arch/x86/include/asm
Edit: /usr/src/linux-headers-5.15.0-181/arch/x86/include/asm/pgtable-3level.h (8963B)
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef _ASM_X86_PGTABLE_3LEVEL_H
#define _ASM_X86_PGTABLE_3LEVEL_H
#include
/*
* Intel Physical Address Extension (PAE) Mode - three-level page
* tables on PPro+ CPUs.
*
* Copyright (C) 1999 Ingo Molnar
*/
#define pte_ERROR(e) \
pr_err("%s:%d: bad pte %p(%08lx%08lx)\n", \
__FILE__, __LINE__, &(e), (e).pte_high, (e).pte_low)
#define pmd_ERROR(e) \
pr_err("%s:%d: bad pmd %p(%016Lx)\n", \
__FILE__, __LINE__, &(e), pmd_val(e))
#define pgd_ERROR(e) \
pr_err("%s:%d: bad pgd %p(%016Lx)\n", \
__FILE__, __LINE__, &(e), pgd_val(e))
/* Rules for using set_pte: the pte being assigned *must* be
* either not present or in a state where the hardware will
* not attempt to update the pte. In places where this is
* not possible, use pte_get_and_clear to obtain the old pte
* value and then use set_pte to update it. -ben
*/
static inline void native_set_pte(pte_t *ptep, pte_t pte)
{
ptep->pte_high = pte.pte_high;
smp_wmb();
ptep->pte_low = pte.pte_low;
}
#define pmd_read_atomic pmd_read_atomic
/*
* pte_offset_map_lock() on 32-bit PAE kernels was reading the pmd_t with
* a "*pmdp" dereference done by GCC. Problem is, in certain places
* where pte_offset_map_lock() is called, concurrent page faults are
* allowed, if the mmap_lock is hold for reading. An example is mincore
* vs page faults vs MADV_DONTNEED. On the page fault side
* pmd_populate() rightfully does a set_64bit(), but if we're reading the
* pmd_t with a "*pmdp" on the mincore side, a SMP race can happen
* because GCC will not read the 64-bit value of the pmd atomically.
*
* To fix this all places running pte_offset_map_lock() while holding the
* mmap_lock in read mode, shall read the pmdp pointer using this
* function to know if the pmd is null or not, and in turn to know if
* they can run pte_offset_map_lock() or pmd_trans_huge() or other pmd
* operations.
*
* Without THP if the mmap_lock is held for reading, the pmd can only
* transition from null to not null while pmd_read_atomic() runs. So
* we can always return atomic pmd values with this function.
*
* With THP if the mmap_lock is held for reading, the pmd can become
* trans_huge or none or point to a pte (and in turn become "stable")
* at any time under pmd_read_atomic(). We could read it truly
* atomically here with an atomic64_read() for the THP enabled case (and
* it would be a whole lot simpler), but to avoid using cmpxchg8b we
* only return an atomic pmdval if the low part of the pmdval is later
* found to be stable (i.e. pointing to a pte). We are also returning a
* 'none' (zero) pmdval if the low part of the pmd is zero.
*
* In some cases the high and low part of the pmdval returned may not be
* consistent if THP is enabled (the low part may point to previously
* mapped hugepage, while the high part may point to a more recently
* mapped hugepage), but pmd_none_or_trans_huge_or_clear_bad() only
* needs the low part of the pmd to be read atomically to decide if the
* pmd is unstable or not, with the only exception when the low part
* of the pmd is zero, in which case we return a 'none' pmd.
*/
static inline pmd_t pmd_read_atomic(pmd_t *pmdp)
{
pmdval_t ret;
u32 *tmp = (u32 *)pmdp;
ret = (pmdval_t) (*tmp);
if (ret) {
/*
* If the low part is null, we must not read the high part
* or we can end up with a partial pmd.
*/
smp_rmb();
ret |= ((pmdval_t)*(tmp + 1)) << 32;
}
return (pmd_t) { ret };
}
static inline void native_set_pte_atomic(pte_t *ptep, pte_t pte)
{
set_64bit((unsigned long long *)(ptep), native_pte_val(pte));
}
static inline void native_set_pmd(pmd_t *pmdp, pmd_t pmd)
{
set_64bit((unsigned long long *)(pmdp), native_pmd_val(pmd));
}
static inline void native_set_pud(pud_t *pudp, pud_t pud)
{
#ifdef CONFIG_PAGE_TABLE_ISOLATION
pud.p4d.pgd = pti_set_user_pgtbl(&pudp->p4d.pgd, pud.p4d.pgd);
#endif
set_64bit((unsigned long long *)(pudp), native_pud_val(pud));
}
/*
* For PTEs and PDEs, we must clear the P-bit first when clearing a page table
* entry, so clear the bottom half first and enforce ordering with a compiler
* barrier.
*/
static inline void native_pte_clear(struct mm_struct *mm, unsigned long addr,
pte_t *ptep)
{
ptep->pte_low = 0;
smp_wmb();
ptep->pte_high = 0;
}
static inline void native_pmd_clear(pmd_t *pmd)
{
u32 *tmp = (u32 *)pmd;
*tmp = 0;
smp_wmb();
*(tmp + 1) = 0;
}
static inline void native_pud_clear(pud_t *pudp)
{
}
static inline void pud_clear(pud_t *pudp)
{
set_pud(pudp, __pud(0));
/*
* According to Intel App note "TLBs, Paging-Structure Caches,
* and Their Invalidation", April 2007, document 317080-001,
* section 8.1: in PAE mode we explicitly have to flush the
* TLB via cr3 if the top-level pgd is changed...
*
* Currently all places where pud_clear() is called either have
* flush_tlb_mm() followed or don't need TLB flush (x86_64 code or
* pud_clear_bad()), so we don't need TLB flush here.
*/
}
#ifdef CONFIG_SMP
static inline pte_t native_ptep_get_and_clear(pte_t *ptep)
{
pte_t res;
res.pte = (pteval_t)arch_atomic64_xchg((atomic64_t *)ptep, 0);
return res;
}
#else
#define native_ptep_get_and_clear(xp) native_local_ptep_get_and_clear(xp)
#endif
union split_pmd {
struct {
u32 pmd_low;
u32 pmd_high;
};
pmd_t pmd;
};
#ifdef CONFIG_SMP
static inline pmd_t native_pmdp_get_and_clear(pmd_t *pmdp)
{
union split_pmd res, *orig = (union split_pmd *)pmdp;
/* xchg acts as a barrier before setting of the high bits */
res.pmd_low = xchg(&orig->pmd_low, 0);
res.pmd_high = orig->pmd_high;
orig->pmd_high = 0;
return res.pmd;
}
#else
#define native_pmdp_get_and_clear(xp) native_local_pmdp_get_and_clear(xp)
#endif
#ifndef pmdp_establish
#define pmdp_establish pmdp_establish
static inline pmd_t pmdp_establish(struct vm_area_struct *vma,
unsigned long address, pmd_t *pmdp, pmd_t pmd)
{
pmd_t old;
/*
* If pmd has present bit cleared we can get away without expensive
* cmpxchg64: we can update pmdp half-by-half without racing with
* anybody.
*/
if (!(pmd_val(pmd) & _PAGE_PRESENT)) {
union split_pmd old, new, *ptr;
ptr = (union split_pmd *)pmdp;
new.pmd = pmd;
/* xchg acts as a barrier before setting of the high bits */
old.pmd_low = xchg(&ptr->pmd_low, new.pmd_low);
old.pmd_high = ptr->pmd_high;
ptr->pmd_high = new.pmd_high;
return old.pmd;
}
do {
old = *pmdp;
} while (cmpxchg64(&pmdp->pmd, old.pmd, pmd.pmd) != old.pmd);
return old;
}
#endif
#ifdef CONFIG_SMP
union split_pud {
struct {
u32 pud_low;
u32 pud_high;
};
pud_t pud;
};
static inline pud_t native_pudp_get_and_clear(pud_t *pudp)
{
union split_pud res, *orig = (union split_pud *)pudp;
#ifdef CONFIG_PAGE_TABLE_ISOLATION
pti_set_user_pgtbl(&pudp->p4d.pgd, __pgd(0));
#endif
/* xchg acts as a barrier before setting of the high bits */
res.pud_low = xchg(&orig->pud_low, 0);
res.pud_high = orig->pud_high;
orig->pud_high = 0;
return res.pud;
}
#else
#define native_pudp_get_and_clear(xp) native_local_pudp_get_and_clear(xp)
#endif
/* Encode and de-code a swap entry */
#define SWP_TYPE_BITS 5
#define SWP_OFFSET_FIRST_BIT (_PAGE_BIT_PROTNONE + 1)
/* We always extract/encode the offset by shifting it all the way up, and then down again */
#define SWP_OFFSET_SHIFT (SWP_OFFSET_FIRST_BIT + SWP_TYPE_BITS)
#define MAX_SWAPFILES_CHECK() BUILD_BUG_ON(MAX_SWAPFILES_SHIFT > 5)
#define __swp_type(x) (((x).val) & 0x1f)
#define __swp_offset(x) ((x).val >> 5)
#define __swp_entry(type, offset) ((swp_entry_t){(type) | (offset) << 5})
/*
* Normally, __swp_entry() converts from arch-independent swp_entry_t to
* arch-dependent swp_entry_t, and __swp_entry_to_pte() just stores the result
* to pte. But here we have 32bit swp_entry_t and 64bit pte, and need to use the
* whole 64 bits. Thus, we shift the "real" arch-dependent conversion to
* __swp_entry_to_pte() through the following helper macro based on 64bit
* __swp_entry().
*/
#define __swp_pteval_entry(type, offset) ((pteval_t) { \
(~(pteval_t)(offset) << SWP_OFFSET_SHIFT >> SWP_TYPE_BITS) \
| ((pteval_t)(type) << (64 - SWP_TYPE_BITS)) })
#define __swp_entry_to_pte(x) ((pte_t){ .pte = \
__swp_pteval_entry(__swp_type(x), __swp_offset(x)) })
/*
* Analogically, __pte_to_swp_entry() doesn't just extract the arch-dependent
* swp_entry_t, but also has to convert it from 64bit to the 32bit
* intermediate representation, using the following macros based on 64bit
* __swp_type() and __swp_offset().
*/
#define __pteval_swp_type(x) ((unsigned long)((x).pte >> (64 - SWP_TYPE_BITS)))
#define __pteval_swp_offset(x) ((unsigned long)(~((x).pte) << SWP_TYPE_BITS >> SWP_OFFSET_SHIFT))
#define __pte_to_swp_entry(pte) (__swp_entry(__pteval_swp_type(pte), \
__pteval_swp_offset(pte)))
#include
#endif /* _ASM_X86_PGTABLE_3LEVEL_H */