/usr/src/linux-headers-5.15.0-190/arch/arm/include/debug
Edit: /usr/src/linux-headers-5.15.0-190/arch/arm/include/debug/zynq.S (1277B)
/* SPDX-License-Identifier: GPL-2.0-only */
/*
* Debugging macro include header
*
* Copyright (C) 2011 Xilinx
*/
#define UART_CR_OFFSET 0x00 /* Control Register [8:0] */
#define UART_SR_OFFSET 0x2C /* Channel Status [11:0] */
#define UART_FIFO_OFFSET 0x30 /* FIFO [15:0] or [7:0] */
#define UART_SR_TXFULL 0x00000010 /* TX FIFO full */
#define UART_SR_TXEMPTY 0x00000008 /* TX FIFO empty */
#define UART0_PHYS 0xE0000000
#define UART0_VIRT 0xF0800000
#define UART1_PHYS 0xE0001000
#define UART1_VIRT 0xF0801000
#if IS_ENABLED(CONFIG_DEBUG_ZYNQ_UART1)
# define LL_UART_PADDR UART1_PHYS
# define LL_UART_VADDR UART1_VIRT
#else
# define LL_UART_PADDR UART0_PHYS
# define LL_UART_VADDR UART0_VIRT
#endif
.macro addruart, rp, rv, tmp
ldr \rp, =LL_UART_PADDR @ physical
ldr \rv, =LL_UART_VADDR @ virtual
.endm
.macro senduart,rd,rx
strb \rd, [\rx, #UART_FIFO_OFFSET] @ TXDATA
.endm
.macro waituartcts,rd,rx
.endm
.macro waituarttxrdy,rd,rx
1001: ldr \rd, [\rx, #UART_SR_OFFSET]
ARM_BE8( rev \rd, \rd )
tst \rd, #UART_SR_TXEMPTY
beq 1001b
.endm
.macro busyuart,rd,rx
1002: ldr \rd, [\rx, #UART_SR_OFFSET] @ get status register
ARM_BE8( rev \rd, \rd )
tst \rd, #UART_SR_TXFULL @
bne 1002b @ wait if FIFO is full
.endm