/usr/src/linux-headers-5.15.0-190/arch/powerpc/include/asm
Edit: /usr/src/linux-headers-5.15.0-190/arch/powerpc/include/asm/dcr-regs.h (5846B)
/* SPDX-License-Identifier: GPL-2.0 */
/*
* Common DCR / SDR / CPR register definitions used on various IBM/AMCC
* 4xx processors
*
* Copyright 2007 Benjamin Herrenschmidt, IBM Corp
*
*
* Mostly lifted from asm-ppc/ibm4xx.h by
*
* Copyright (c) 1999 Grant Erickson
*
*/
#ifndef __DCR_REGS_H__
#define __DCR_REGS_H__
/*
* Most DCRs used for controlling devices such as the MAL, DMA engine,
* etc... are obtained for the device tree.
*
* The definitions in this files are fixed DCRs and indirect DCRs that
* are commonly used outside of specific drivers or refer to core
* common registers that may occasionally have to be tweaked outside
* of the driver main register set
*/
/* CPRs (440GX and 440SP/440SPe) */
#define DCRN_CPR0_CONFIG_ADDR 0xc
#define DCRN_CPR0_CONFIG_DATA 0xd
/* SDRs (440GX and 440SP/440SPe) */
#define DCRN_SDR0_CONFIG_ADDR 0xe
#define DCRN_SDR0_CONFIG_DATA 0xf
#define SDR0_PFC0 0x4100
#define SDR0_PFC1 0x4101
#define SDR0_PFC1_EPS 0x1c00000
#define SDR0_PFC1_EPS_SHIFT 22
#define SDR0_PFC1_RMII 0x02000000
#define SDR0_MFR 0x4300
#define SDR0_MFR_TAH0 0x80000000 /* TAHOE0 Enable */
#define SDR0_MFR_TAH1 0x40000000 /* TAHOE1 Enable */
#define SDR0_MFR_PCM 0x10000000 /* PPC440GP irq compat mode */
#define SDR0_MFR_ECS 0x08000000 /* EMAC int clk */
#define SDR0_MFR_T0TXFL 0x00080000
#define SDR0_MFR_T0TXFH 0x00040000
#define SDR0_MFR_T1TXFL 0x00020000
#define SDR0_MFR_T1TXFH 0x00010000
#define SDR0_MFR_E0TXFL 0x00008000
#define SDR0_MFR_E0TXFH 0x00004000
#define SDR0_MFR_E0RXFL 0x00002000
#define SDR0_MFR_E0RXFH 0x00001000
#define SDR0_MFR_E1TXFL 0x00000800
#define SDR0_MFR_E1TXFH 0x00000400
#define SDR0_MFR_E1RXFL 0x00000200
#define SDR0_MFR_E1RXFH 0x00000100
#define SDR0_MFR_E2TXFL 0x00000080
#define SDR0_MFR_E2TXFH 0x00000040
#define SDR0_MFR_E2RXFL 0x00000020
#define SDR0_MFR_E2RXFH 0x00000010
#define SDR0_MFR_E3TXFL 0x00000008
#define SDR0_MFR_E3TXFH 0x00000004
#define SDR0_MFR_E3RXFL 0x00000002
#define SDR0_MFR_E3RXFH 0x00000001
#define SDR0_UART0 0x0120
#define SDR0_UART1 0x0121
#define SDR0_UART2 0x0122
#define SDR0_UART3 0x0123
#define SDR0_CUST0 0x4000
/* SDR for 405EZ */
#define DCRN_SDR_ICINTSTAT 0x4510
#define ICINTSTAT_ICRX 0x80000000
#define ICINTSTAT_ICTX0 0x40000000
#define ICINTSTAT_ICTX1 0x20000000
#define ICINTSTAT_ICTX 0x60000000
/* SDRs (460EX/460GT) */
#define SDR0_ETH_CFG 0x4103
#define SDR0_ETH_CFG_ECS 0x00000100 /* EMAC int clk source */
/*
* All those DCR register addresses are offsets from the base address
* for the SRAM0 controller (e.g. 0x20 on 440GX). The base address is
* excluded here and configured in the device tree.
*/
#define DCRN_SRAM0_SB0CR 0x00
#define DCRN_SRAM0_SB1CR 0x01
#define DCRN_SRAM0_SB2CR 0x02
#define DCRN_SRAM0_SB3CR 0x03
#define SRAM_SBCR_BU_MASK 0x00000180
#define SRAM_SBCR_BS_64KB 0x00000800
#define SRAM_SBCR_BU_RO 0x00000080
#define SRAM_SBCR_BU_RW 0x00000180
#define DCRN_SRAM0_BEAR 0x04
#define DCRN_SRAM0_BESR0 0x05
#define DCRN_SRAM0_BESR1 0x06
#define DCRN_SRAM0_PMEG 0x07
#define DCRN_SRAM0_CID 0x08
#define DCRN_SRAM0_REVID 0x09
#define DCRN_SRAM0_DPC 0x0a
#define SRAM_DPC_ENABLE 0x80000000
/*
* All those DCR register addresses are offsets from the base address
* for the SRAM0 controller (e.g. 0x30 on 440GX). The base address is
* excluded here and configured in the device tree.
*/
#define DCRN_L2C0_CFG 0x00
#define L2C_CFG_L2M 0x80000000
#define L2C_CFG_ICU 0x40000000
#define L2C_CFG_DCU 0x20000000
#define L2C_CFG_DCW_MASK 0x1e000000
#define L2C_CFG_TPC 0x01000000
#define L2C_CFG_CPC 0x00800000
#define L2C_CFG_FRAN 0x00200000
#define L2C_CFG_SS_MASK 0x00180000
#define L2C_CFG_SS_256 0x00000000
#define L2C_CFG_CPIM 0x00040000
#define L2C_CFG_TPIM 0x00020000
#define L2C_CFG_LIM 0x00010000
#define L2C_CFG_PMUX_MASK 0x00007000
#define L2C_CFG_PMUX_SNP 0x00000000
#define L2C_CFG_PMUX_IF 0x00001000
#define L2C_CFG_PMUX_DF 0x00002000
#define L2C_CFG_PMUX_DS 0x00003000
#define L2C_CFG_PMIM 0x00000800
#define L2C_CFG_TPEI 0x00000400
#define L2C_CFG_CPEI 0x00000200
#define L2C_CFG_NAM 0x00000100
#define L2C_CFG_SMCM 0x00000080
#define L2C_CFG_NBRM 0x00000040
#define L2C_CFG_RDBW 0x00000008 /* only 460EX/GT */
#define DCRN_L2C0_CMD 0x01
#define L2C_CMD_CLR 0x80000000
#define L2C_CMD_DIAG 0x40000000
#define L2C_CMD_INV 0x20000000
#define L2C_CMD_CCP 0x10000000
#define L2C_CMD_CTE 0x08000000
#define L2C_CMD_STRC 0x04000000
#define L2C_CMD_STPC 0x02000000
#define L2C_CMD_RPMC 0x01000000
#define L2C_CMD_HCC 0x00800000
#define DCRN_L2C0_ADDR 0x02
#define DCRN_L2C0_DATA 0x03
#define DCRN_L2C0_SR 0x04
#define L2C_SR_CC 0x80000000
#define L2C_SR_CPE 0x40000000
#define L2C_SR_TPE 0x20000000
#define L2C_SR_LRU 0x10000000
#define L2C_SR_PCS 0x08000000
#define DCRN_L2C0_REVID 0x05
#define DCRN_L2C0_SNP0 0x06
#define DCRN_L2C0_SNP1 0x07
#define L2C_SNP_BA_MASK 0xffff0000
#define L2C_SNP_SSR_MASK 0x0000f000
#define L2C_SNP_SSR_32G 0x0000f000
#define L2C_SNP_ESR 0x00000800
/*
* DCR register offsets for 440SP/440SPe I2O/DMA controller.
* The base address is configured in the device tree.
*/
#define DCRN_I2O0_IBAL 0x006
#define DCRN_I2O0_IBAH 0x007
#define I2O_REG_ENABLE 0x00000001 /* Enable I2O/DMA access */
/* 440SP/440SPe Software Reset DCR */
#define DCRN_SDR0_SRST 0x0200
#define DCRN_SDR0_SRST_I2ODMA (0x80000000 >> 15) /* Reset I2O/DMA */
/* 440SP/440SPe Memory Queue DCR offsets */
#define DCRN_MQ0_XORBA 0x04
#define DCRN_MQ0_CF2H 0x06
#define DCRN_MQ0_CFBHL 0x0f
#define DCRN_MQ0_BAUH 0x10
/* HB/LL Paths Configuration Register */
#define MQ0_CFBHL_TPLM 28
#define MQ0_CFBHL_HBCL 23
#define MQ0_CFBHL_POLY 15
#endif /* __DCR_REGS_H__ */