/usr/src/linux-headers-5.15.0-190/tools/testing/selftests/drivers/net/mlxsw
Edit: /usr/src/linux-headers-5.15.0-190/tools/testing/selftests/drivers/net/mlxsw/qos_lib.sh (1918B)
# SPDX-License-Identifier: GPL-2.0
check_rate()
{
local rate=$1; shift
local min=$1; shift
local what=$1; shift
if ((rate > min)); then
return 0
fi
echo "$what $(humanize $ir) < $(humanize $min)" > /dev/stderr
return 1
}
measure_rate()
{
local sw_in=$1; shift # Where the traffic ingresses the switch
local host_in=$1; shift # Where it ingresses another host
local counter=$1; shift # Counter to use for measurement
local what=$1; shift
local interval=10
local i
local ret=0
# Dips in performance might cause momentary ingress rate to drop below
# 1Gbps. That wouldn't saturate egress and MC would thus get through,
# seemingly winning bandwidth on account of UC. Demand at least 2Gbps
# average ingress rate to somewhat mitigate this.
local min_ingress=2147483648
for i in {5..0}; do
local t0=$(ethtool_stats_get $host_in $counter)
local u0=$(ethtool_stats_get $sw_in $counter)
sleep $interval
local t1=$(ethtool_stats_get $host_in $counter)
local u1=$(ethtool_stats_get $sw_in $counter)
local ir=$(rate $u0 $u1 $interval)
local er=$(rate $t0 $t1 $interval)
if check_rate $ir $min_ingress "$what ingress rate"; then
break
fi
# Fail the test if we can't get the throughput.
if ((i == 0)); then
ret=1
fi
done
echo $ir $er
return $ret
}
bail_on_lldpad()
{
if systemctl is-active --quiet lldpad; then
cat >/dev/stderr <<-EOF
WARNING: lldpad is running
lldpad will likely configure DCB, and this test will
configure Qdiscs. mlxsw does not support both at the
same time, one of them is arbitrarily going to overwrite
the other. That will cause spurious failures (or,
unlikely, passes) of this test.
EOF
if [[ -z $ALLOW_LLDPAD ]]; then
cat >/dev/stderr <<-EOF
If you want to run the test anyway, please set
an environment variable ALLOW_LLDPAD to a
non-empty string.
EOF
exit 1
else
return
fi
fi
}