/
usr
/
src
/
linux-headers-5.15.0-181
/
drivers
/
dma
/
ti
/
/usr/src/linux-headers-5.15.0-181/drivers/dma/ti
mkdir
upload
Name
Size
Mode
Actions
Kconfig
1735
0644
edit
dl
rm
Makefile
417
0644
edit
dl
rm
Edit:
/usr/src/linux-headers-5.15.0-181/drivers/dma/ti/Kconfig
(1735B)
# SPDX-License-Identifier: GPL-2.0-only # # Texas Instruments DMA drivers # config TI_CPPI41 tristate "Texas Instruments CPPI 4.1 DMA support" depends on (ARCH_OMAP || ARCH_DAVINCI_DA8XX) select DMA_ENGINE help The Communications Port Programming Interface (CPPI) 4.1 DMA engine is currently used by the USB driver on AM335x and DA8xx platforms. config TI_EDMA tristate "Texas Instruments EDMA support" depends on ARCH_DAVINCI || ARCH_OMAP || ARCH_KEYSTONE || COMPILE_TEST select DMA_ENGINE select DMA_VIRTUAL_CHANNELS select TI_DMA_CROSSBAR if (ARCH_OMAP || COMPILE_TEST) default y help Enable support for the TI EDMA (Enhanced DMA) controller. This DMA engine is found on TI DaVinci, AM33xx, AM43xx, DRA7xx and Keystone 2 parts. config DMA_OMAP tristate "Texas Instruments sDMA (omap-dma) support" depends on ARCH_OMAP || COMPILE_TEST select DMA_ENGINE select DMA_VIRTUAL_CHANNELS select TI_DMA_CROSSBAR if (SOC_DRA7XX || COMPILE_TEST) default y help Enable support for the TI sDMA (System DMA or DMA4) controller. This DMA engine is found on OMAP and DRA7xx parts. config TI_K3_UDMA bool "Texas Instruments UDMA support" depends on ARCH_K3 depends on TI_SCI_PROTOCOL depends on TI_SCI_INTA_IRQCHIP select DMA_ENGINE select DMA_VIRTUAL_CHANNELS select TI_K3_RINGACC select TI_K3_PSIL help Enable support for the TI UDMA (Unified DMA) controller. This DMA engine is used in AM65x and j721e. config TI_K3_UDMA_GLUE_LAYER bool "Texas Instruments UDMA Glue layer for non DMAengine users" depends on ARCH_K3 depends on TI_K3_UDMA help Say y here to support the K3 NAVSS DMA glue interface If unsure, say N. config TI_K3_PSIL bool config TI_DMA_CROSSBAR bool
Save
cmd:
run