/
usr
/
src
/
linux-headers-5.15.0-181
/
drivers
/
mux
/
/usr/src/linux-headers-5.15.0-181/drivers/mux
mkdir
upload
Name
Size
Mode
Actions
Kconfig
1779
0644
edit
dl
rm
Makefile
423
0644
edit
dl
rm
Edit:
/usr/src/linux-headers-5.15.0-181/drivers/mux/Kconfig
(1779B)
# SPDX-License-Identifier: GPL-2.0 # # Multiplexer devices # config MULTIPLEXER tristate menu "Multiplexer drivers" depends on MULTIPLEXER config MUX_ADG792A tristate "Analog Devices ADG792A/ADG792G Multiplexers" depends on I2C help ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers The driver supports both operating the three multiplexers in parallel and operating them independently. To compile the driver as a module, choose M here: the module will be called mux-adg792a. config MUX_ADGS1408 tristate "Analog Devices ADGS1408/ADGS1409 Multiplexers" depends on SPI help ADGS1408 8:1 multiplexer and ADGS1409 double 4:1 multiplexer switches. To compile the driver as a module, choose M here: the module will be called mux-adgs1408. config MUX_GPIO tristate "GPIO-controlled Multiplexer" depends on GPIOLIB || COMPILE_TEST help GPIO-controlled Multiplexer controller. The driver builds a single multiplexer controller using a number of gpio pins. For N pins, there will be 2^N possible multiplexer states. The GPIO pins can be connected (by the hardware) to several multiplexers, which in that case will be operated in parallel. To compile the driver as a module, choose M here: the module will be called mux-gpio. config MUX_MMIO tristate "MMIO/Regmap register bitfield-controlled Multiplexer" depends on OF || COMPILE_TEST help MMIO/Regmap register bitfield-controlled Multiplexer controller. The driver builds multiplexer controllers for bitfields in either a syscon register or a driver regmap register. For N bit wide bitfields, there will be 2^N possible multiplexer states. To compile the driver as a module, choose M here: the module will be called mux-mmio. endmenu
Save
cmd:
run