FM / hsr

/usr/src/linux-headers-5.15.0-181/net/hsr/

/usr/src/linux-headers-5.15.0-181/net/hsr

Name	Size	Mode	Actions
Kconfig	1791	0644	edit dl rm
Makefile	230	0644	edit dl rm

Edit: /usr/src/linux-headers-5.15.0-181/net/hsr/Kconfig (1791B)

# SPDX-License-Identifier: GPL-2.0-only
#
# IEC 62439-3 High-availability Seamless Redundancy
#

config HSR
	tristate "High-availability Seamless Redundancy (HSR & PRP)"
	help
	  This enables IEC 62439 defined High-availability Seamless
	  Redundancy (HSR) and Parallel Redundancy Protocol (PRP).

If you say Y here, then your Linux box will be able to act as a
	  DANH ("Doubly attached node implementing HSR") or DANP ("Doubly
	  attached node implementing PRP"). For this to work, your Linux box
	  needs (at least) two physical Ethernet interfaces.

For DANH, it must be connected as a node in a ring network together
	  with other HSR capable nodes. All Ethernet frames sent over the HSR
	  device will be sent in both directions on the ring (over both slave
	  ports), giving a redundant, instant fail-over network. Each HSR node
	  in the ring acts like a bridge for HSR frames, but filters frames
	  that have been forwarded earlier.

For DANP, it must be connected as a node connecting to two
	  separate networks over the two slave interfaces. Like HSR, Ethernet
	  frames sent over the PRP device will be sent to both networks giving
	  a redundant, instant fail-over network. Unlike HSR, PRP networks
	  can have Singly Attached Nodes (SAN) such as PC, printer, bridges
	  etc and will be able to communicate with DANP nodes.

This code is a "best effort" to comply with the HSR standard as
	  described in IEC 62439-3:2010 (HSRv0) and IEC 62439-3:2012 (HSRv1),
	  and PRP standard described in IEC 62439-4:2012 (PRP), but no
	  compliancy tests have been made. Use iproute2 to select the protocol
	  you would like to use.

You need to perform any and all necessary tests yourself before
	  relying on this code in a safety critical system!

If unsure, say N.

cmd: