/
usr
/
src
/
linux-headers-5.15.0-190
/
drivers
/
net
/
ethernet
/
micrel
/
/usr/src/linux-headers-5.15.0-190/drivers/net/ethernet/micrel
mkdir
upload
Name
Size
Mode
Actions
Kconfig
1600
0644
edit
dl
rm
Makefile
272
0644
edit
dl
rm
Edit:
/usr/src/linux-headers-5.15.0-190/drivers/net/ethernet/micrel/Kconfig
(1600B)
# SPDX-License-Identifier: GPL-2.0-only # # Micrel device configuration # config NET_VENDOR_MICREL bool "Micrel devices" default y depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM help If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Micrel devices. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_MICREL config KS8842 tristate "Micrel KSZ8841/42 with generic bus interface" depends on HAS_IOMEM && DMA_ENGINE help This platform driver is for KSZ8841(1-port) / KS8842(2-port) ethernet switch chip (managed, VLAN, QoS) from Micrel or Timberdale(FPGA). config KS8851 tristate "Micrel KS8851 SPI" depends on SPI select MII select CRC32 select EEPROM_93CX6 select PHYLIB select MICREL_PHY help SPI driver for Micrel KS8851 SPI attached network chip. config KS8851_MLL tristate "Micrel KS8851 MLL" depends on HAS_IOMEM depends on PTP_1588_CLOCK_OPTIONAL select MII select CRC32 select EEPROM_93CX6 select PHYLIB select MICREL_PHY help This platform driver is for Micrel KS8851 Address/data bus multiplexed network chip. config KSZ884X_PCI tristate "Micrel KSZ8841/2 PCI" depends on PCI select MII select CRC32 help This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. To compile this driver as a module, choose M here. The module will be called ksz884x. endif # NET_VENDOR_MICREL
Save
cmd:
run