/
usr
/
src
/
linux-headers-5.15.0-190
/
drivers
/
net
/
wireless
/
microchip
/
wilc1000
/
/usr/src/linux-headers-5.15.0-190/drivers/net/wireless/microchip/wilc1000
mkdir
upload
Name
Size
Mode
Actions
Kconfig
1987
0644
edit
dl
rm
Makefile
295
0644
edit
dl
rm
Edit:
/usr/src/linux-headers-5.15.0-190/drivers/net/wireless/microchip/wilc1000/Kconfig
(1987B)
# SPDX-License-Identifier: GPL-2.0 config WILC1000 tristate help Add support for the Atmel WILC1000 802.11 b/g/n SoC. This provides Wi-FI over an SDIO or SPI interface, and is usually found in IoT devices. This module only support IEEE 802.11n WiFi. config WILC1000_SDIO tristate "Atmel WILC1000 SDIO (WiFi only)" depends on CFG80211 && INET && MMC select WILC1000 help This module adds support for the SDIO interface of adapters using WILC1000 chipset. The Atmel WILC1000 SDIO is a full speed interface. It meets SDIO card specification version 2.0. The interface supports the 1-bit/4-bit SD transfer mode at the clock range of 0-50 MHz. The host can use this interface to read and write from any register within the chip as well as configure the WILC1000 for data DMA. To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select this if your platform is using the SDIO bus. config WILC1000_SPI tristate "Atmel WILC1000 SPI (WiFi only)" depends on CFG80211 && INET && SPI select WILC1000 select CRC7 select CRC_ITU_T help This module adds support for the SPI interface of adapters using WILC1000 chipset. The Atmel WILC1000 has a Serial Peripheral Interface (SPI) that operates as a SPI slave. This SPI interface can be used for control and for serial I/O of 802.11 data. The SPI is a full-duplex slave synchronous serial interface that is available immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to VDDIO. Select this if your platform is using the SPI bus. config WILC1000_HW_OOB_INTR bool "WILC1000 out of band interrupt" depends on WILC1000_SDIO help This option enables out-of-band interrupt support for the WILC1000 chipset. This OOB interrupt is intended to provide a faster interrupt mechanism for SDIO host controllers that don't support SDIO interrupt. Select this option If the SDIO host controller in your platform doesn't support SDIO time division interrupt.
Save
cmd:
run